Adjusting motion sensor flood lights11/11/2023 Two types of motion detectors are available: After you have completed the sensitivity adjustment, set the slide switch to the "ON" position.The motion detector will turn off after approximately 4 seconds of no motion within the detection area. Set the sensitivity adjustment, proceed to the detection area and if necessary adjust the sensitivity until you reach the desired result. This testing is a trial and error method. Using the sensitivity adjustment you can set the motion detector to activate at different distances within the detection zone.Note: Always point the lamp holders with a slight downward profile in order to avoid having the lamp holders fill with water which could cause the lamp to burn out or a short circuit within the lamp socket. As a general rule, do not allow the lamps to be closer than 1/2 inch from the detector. Aim the lamps away from the detector by adjusting the lamp holders.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |